LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Cylinder Head >> COVER(S), Cylinder Head >> Removal >> Removal

COVER(S), Cylinder Head: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Ignition Coil Mounting Bolts
GC0080075Courtesy of CHRYSLER LLC
  1. Disconnect negative battery cable.
  2. Disconnect ignition coil connector (1).
  3. Remove ignition coil retaining bolts (3).
    Fig 2: Removing/Installing Ignition Coil
    GC0080076Courtesy of CHRYSLER LLC
  4. Remove ignition coil (1).
    Fig 3: Cylinder Head Cover Torque Sequence
    GC0080292Courtesy of CHRYSLER LLC
  5. Remove cylinder head cover retaining bolts.
    Fig 4: Cylinder Head Components
    GC0080293Courtesy of CHRYSLER LLC
  6. Remove cylinder head cover (1).
    NOTE: The gasket (2) may be used again, provided no cuts, tears, or deformation have occurred.
scientia non olet · About LEMON Manuals