Shifter - Floor Mount

WARNING: This page is about a different variant/trim than selected.

Fig 1: Shifter Lower Trim

Courtesy of CHRYSLER LLC

If a new shifter assembly is being installed, use a trim stick (1) to separate the shift knob lower trim (3) from the shift knob (2).

Fig 2: Removing Shift Knob
Courtesy of CHRYSLER LLC
Pull up on the shift knob (1) to remove the knob from the shaft then remove the lower trim (2).

Install the lower trim onto the new shifter shaft. Install the shift knob onto the shaft by hand. Install the lower trim onto the shift knob.

Fig 3: Shifter Assembly

Courtesy of CHRYSLER LLC

1 - SHIFTER ASSEMBLY

2 - NUTS

3 - GEARSHIFT CABLE

Install the nuts (2) to hold the shifter assembly (1) onto the floor pan. Tighten nuts to 7 N.m (65 in.lbs.).

Fig 4: Gearshift Cable at Shifter Assembly

Courtesy of CHRYSLER LLC

1 - GEARSHIFT CABLE

2 - CABLE RETAINER AND NOTCH

3 - SHIFTER ASSEMBLY PIN

4 - SHIFT LEVER

5 - ADJUSTMENT BOLT

Place the floor shifter lever in PARK position.
Loosen the adjustment screw (5) on the gearshift cable (1).
Install the gearshift cable (1) to the shift lever pin (3).

Fig 5: Shifter Wiring Connectors
Courtesy of CHRYSLER LLC

1 - SHIFTER ASSEMBLY

2 - WIRING CONNECTORS
Install the wiring harness connectors (2) to the shifter assembly.
Verify that the shift lever is in the PARK position and the transmission park sprag is set by rocking the vehicle.
Tighten the adjustment screw to 7 N.m (65 in.lbs.).
Verify correct shifter, park lock, and BTSI operation.
Install any console parts removed for access to shift lever assembly and shift cables. Refer to Body/Interior/CONSOLE, Floor - Installation .