LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Nag1 Automatic Transmission (Service Information)) >> CABLE, Shift >> Installation >> Floor Mount

Floor Mount

WARNING: This page is about a different variant/trim than selected.
Fig 1: Gearshift Cable Grommet
GC0081251Courtesy of CHRYSLER LLC
1 - GEARSHIFT CABLE
2 - GROMMET
  1. From under the hood, route the gearshift cable (1) through the dash panel and toward the shifter assembly.
  2. From under the hood, install the grommet (2) to the dash panel.
    Fig 2: Gearshift Cable at Shifter Assembly
    GC0081250Courtesy of CHRYSLER LLC
    1 - GEARSHIFT CABLE
    2 - CABLE RETAINER AND NOTCH
    3 - SHIFTER ASSEMBLY PIN
    4 - SHIFT LEVER
    5 - ADJUSTMENT BOLT
  3. Engage the gearshift cable retainer (2) into the notch (2) in the shifter assembly.
  4. Install the gearshift cable (1) onto the shift lever pin (3).
  5. Loosen the cable adjustment screw (5), if necessary.
    Fig 3: Gearshift Cable Routing
    GC0081252Courtesy of CHRYSLER LLC
    1 - GEARSHIFT CABLE
    2 - HEATER HOSES
    3 - TRANSMISSION
  6. From under the hood, route the gearshift cable (1) forward of the air conditioning lines and the heater hoses (2) and toward the transmission (3) manual lever.
  7. Place shifter into PARK.
  8. Raise vehicle.
  9. Verify that the transmission is in the PARK position by trying to rotate the propeller shaft. If the propeller shaft rotates, move the transmission manual shift lever to the full rearward position and turn the propeller shaft until the PARK system is engaged.
    Fig 4: Identifying Gearshift Cable, Eyelet & Manual Shift Lever
    GC0095837Courtesy of CHRYSLER LLC
  10. Route the gearshift cable (1) through the mounting bracket (2).
  11. Engage the gearshift cable (1) eyelet onto the transmission manual shift lever (3).
  12. Install the gearshift cable retaining clip (4) (if equipped).
  13. Lower vehicle.
  14. Verify that the shifter is in the PARK position.
    Fig 5: Gearshift Cable at Shifter Assembly
    GC0081250Courtesy of CHRYSLER LLC
    1 - GEARSHIFT CABLE
    2 - CABLE RETAINER AND NOTCH
    3 - SHIFTER ASSEMBLY PIN
    4 - SHIFT LEVER
    5 - ADJUSTMENT BOLT
  15. Tighten the adjustment screw (5) to 7 N.m (65 in.lbs.).
  16. Verify correct shifter operation.
  17. If necessary, install the shield, covering the gearshift and park lock cables, to the floorpan and install the bolts to hold the shield to the floorpan.
  18. Install the floor console. Refer to Body/Interior/CONSOLE, Floor - Installation , lower instrument panel components. Refer to Body/Instrument Panel/BEZEL, Instrument Panel - Installation and dash panel insulation pad as necessary.
scientia non olet · About LEMON Manuals