LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (42RLE Automatic Transmission (Service Information)) >> SENSOR, Speed, Input >> Removal >> Removal

SENSOR, Speed, Input: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Input Speed Sensor
GC0095809Courtesy of CHRYSLER LLC
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - TRANSMISSION RANGE SENSOR
  1. Raise vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the input speed sensor (1) .
    NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
  4. Remove the bolt holding the input speed sensor (1) to the transmission case.
  5. Remove the input speed sensor (1) from the transmission case.
scientia non olet · About LEMON Manuals