LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (42RLE Automatic Transmission (Service Information)) >> CABLE, Shift >> Removal >> Floor Mount

Floor Mount

WARNING: This page is about a different variant/trim than selected.
  1. Shift transmission into PARK.
  2. Raise vehicle.
    Fig 1: Gearshift Cable, Manual Valve Lever & Mounting Bracket
    GC0095808Courtesy of CHRYSLER LLC
  3. Remove the gearshift cable retaining clip (4) (if equipped).
  4. Disconnect the gearshift cable eyelet (1) at transmission manual shift lever (3) and pull cable out of mounting bracket (2).
  5. Lower the vehicle.
  6. Remove the floor console as necessary to access the shift mechanism and cables. Refer to Body/Interior/CONSOLE, Floor - Removal .
  7. If necessary, remove the bolts holding the shield, covering the gearshift and park lock cables, to the floorpan and remove the shield.
    Fig 2: Gearshift Cable at Shifter Assembly
    GC0081250Courtesy of CHRYSLER LLC
    1 - GEARSHIFT CABLE
    2 - CABLE RETAINER AND NOTCH
    3 - SHIFTER ASSEMBLY PIN
    4 - SHIFT LEVER
    5 - ADJUSTMENT BOLT
  8. Remove the gearshift cable (1) from the shift lever pin (3).
  9. Remove the gearshift cable retainer (2) from the notch (2) in the shifter assembly.
    Fig 3: Gearshift Cable Grommet
    GC0081251Courtesy of CHRYSLER LLC
    1 - GEARSHIFT CABLE
    2 - GROMMET
  10. From under the hood, remove the shift cable grommet (2) from the dash panel.
  11. Remove gearshift cable (1) from vehicle.
scientia non olet · About LEMON Manuals