LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.7L Engine (Service Information)) >> Manifolds >> MANIFOLD, Exhaust >> Removal >> Right Exhaust Manifold

Right Exhaust Manifold

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating Battery
GC0081581Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: RIGHT EXHAUST MANIFOLD
    GC0081660Courtesy of CHRYSLER LLC
  2. Disconnect and remove upstream oxygen sensor (5).
  3. Raise vehicle.
  4. Remove EGR tube at EGR valve (1).
  5. Remove EGR tube at manifold (4).
  6. Disconnect down stream oxygen sensor electrical connector.
  7. Disconnect exhaust pipe from manifold (4). Refer to Exhaust System/CONVERTER, Catalytic - Removal .
  8. Remove upper heat shield (2) and lower heat shield (3).
  9. Remove manifold attaching bolts and remove manifold.
scientia non olet · About LEMON Manuals