LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.7L Engine (Service Information)) >> Manifolds >> MANIFOLD, Exhaust >> Removal >> Left Exhaust Manifold

Left Exhaust Manifold

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating Battery
GC0081581Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: AIR CLEANER HOUSING
    GC0081582Courtesy of CHRYSLER LLC
  2. Disconnect intake air temperature sensor connector.
  3. Remove air cleaner housing assembly (3). See Engine/Air Intake System/BODY, Air Cleaner - Removal .
  4. Remove oil dipstick tube (4).
    Fig 3: LEFT EXHAUST MANIFOLD
    GC0095438Courtesy of CHRYSLER LLC
  5. Disconnect and remove oxygen sensor (2).
  6. Remove upper heat shield (1) and lower heat shield (4).
  7. Raise vehicle on hoist.
  8. Disconnect down stream oxygen sensor connector.
  9. Remove exhaust pipe from manifold. Refer to Exhaust System/CONVERTER, Catalytic - Removal .
  10. Remove exhaust manifold attaching bolts and remove manifold.
scientia non olet · About LEMON Manuals