LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.7L Engine (Service Information)) >> Cylinder Head >> Standard Procedure >> STANDARD PROCEDURE - Cylinder Head Oil Gallery Cup Plug Service >> Notes

STANDARD PROCEDURE - Cylinder Head Oil Gallery Cup Plug Service: Notes

WARNING: This page is about a different variant/trim than selected.
NOTE: Determine which cup plug is leaking before performing this procedure. If necessary, perform an engine oil leak dye test.

Each cylinder head on a 2.7L engine has 6 external oil gallery cup plugs. It is not necessary to remove the original cup plug to install a new cup plug. The cup plug bore is deep enough to allow for two plugs. If it becomes necessary to service an oil gallery cup plug, perform the Repair Procedure.

NOTE: Inspect the cup plug bore in question for the presence of two cup plugs. If the cup plug flange is just inside (1-2 mm) the chamfered edge of the bore two cup plugs are already in place and the cylinder head cannot be repaired.
scientia non olet · About LEMON Manuals