LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.7L Engine (Service Information)) >> Cylinder Head >> COVER(S), Cylinder Head >> Removal >> Right

COVER(S), Cylinder Head: Removal: Right

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating Battery
GC0081581Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable.
    Fig 2: COIL CONNECTORS
    GC0081610Courtesy of CHRYSLER LLC
  2. Remove upper intake manifold. See Engine/Manifolds/MANIFOLD, Intake - Removal .
  3. Disconnect electrical connectors from ignition coils (1).
    Fig 3: CAPACITOR CONNECTOR - RIGHT
    GC0081613Courtesy of CHRYSLER LLC
  4. Disconnect capacitor electrical connector (2).
  5. Remove PCV hose from cylinder head cover grommet.
  6. Remove ground strap from cylinder head cover stud (1).
  7. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
  8. Remove fastener attaching ignition coil capacitor.
  9. Remove ignition coils.
    Fig 4: FOAM INSULATOR
    GC0081614Courtesy of CHRYSLER LLC
  10. Remove foam insulator (1).
    Fig 5: Cylinder Head Covers
    GC0095405Courtesy of CHRYSLER LLC
  11. Loosen all cylinder head cover fasteners.
    NOTE: Cylinder head cover attaching bolts are captured to the cover.
    CAUTION: Make certain the double ended studs in the center of the cylinder head cover are loose before attempting to remove cover.
  12. Remove cylinder head cover.
scientia non olet · About LEMON Manuals