LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.7L Engine (Service Information)) >> Cylinder Head >> COVER(S), Cylinder Head >> Installation >> Right

COVER(S), Cylinder Head: Installation: Right

WARNING: This page is about a different variant/trim than selected.
Fig 1: Cylinder Head Cover Gasket & Spark Plug Seals
GC0095406Courtesy of CHRYSLER LLC
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1) and (2) as necessary.
    Fig 2: Cylinder Head Covers
    GC0095405Courtesy of CHRYSLER LLC
  2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
  3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 N.m (105 in. lbs.).
    Fig 3: COIL CONNECTORS
    GC0081610Courtesy of CHRYSLER LLC
  4. Install ignition coils (1).
    Fig 4: CAPACITOR CONNECTOR - RIGHT
    GC0081613Courtesy of CHRYSLER LLC
  5. Install ignition coil capacitor (2) and fastener.
  6. Connect ground strap (1) to cylinder head cover stud.
  7. Connect PCV hose to cylinder head cover grommet.
  8. Connect all electrical connectors and harness clips.
    Fig 5: FOAM INSULATOR
    GC0081614Courtesy of CHRYSLER LLC
  9. Install foam insulator (1) on top of cylinder head cover (2).
  10. Install upper intake manifold. See Engine/Manifolds/MANIFOLD, Intake - Installation .
    Fig 6: Locating Battery
    GC0081581Courtesy of CHRYSLER LLC
  11. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals