Cigar Lighter/Power Outlet: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cigar Lighter/Power Outlet Base

Courtesy of DAIMLERCHRYSLER CORP.

This procedure applies to the Front Console and Rear Cargo Area mounted outlets on this vehicle. If the instrument panel mounted cigar lighter/power outlet is defective, the entire accessory switch bezel must be replaced.

Disconnect and isolate the battery negative cable.
Look inside and note position of the retaining bosses (1).
Using external snap ring pliers with 90 degree tips. Insert pliers with tips against bosses and squeeze forcing bosses out of base.
Pull out the base through mounting ring (4) by gently rocking pliers (3).
Disconnect the base wires.
Set base aside and remove base mount ring.