LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Vehicle Theft Security System - Electrical Diagnostics) >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B223B-Vehicle Configuration Mismatch >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  CONFIGURE THE INTRUSION TRANSCEIVER MODULE 
    NOTE: Before proceeding check the vehicles Intrusion Sensor for the correct part number for this vehicle and replace if necessary.

    Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.

    With the scan tool, clear DTC(s).

    Turn the ignition off and remove the key from the ignition.

    Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.

    Disarm the VTSS.

    Using the scan tool, read DTC(s).

    Does the DTC reset? 

    Yes 

    1. Replace the Intrusion Transceiver Module (Refer to REMOVAL) .
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - BODY VERIFICATION TEST - VER 1) , also see (STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .

    No 

    1. Test complete.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - BODY VERIFICATION TEST - VER 1) , also see (STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .
scientia non olet · About LEMON Manuals