LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Suspension System) >> Rear Suspension >> Hub / Bearing >> Installation >> Rear Drum Brake Vehicles

Rear Drum Brake Vehicles

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: DRUM BRAKE MOUNTING TO AXLE
GC0041091Courtesy of DAIMLERCHRYSLER CORP.
  1. Slide the hub and bearing (7) onto the spindle (10).
  2. Install a NEW hub nut (3) on the spindle. Tighten the nut to 217 N.m (160 ft. lbs.).
  3. Install the hub and bearing dust cap (4).
  4. Adjust the rear brakes as necessary. (Refer to BRAKES/HYDRAULIC/MECHANICAL/BRAKE PADS/SHOES - ADJUSTMENTS)
  5. Install the brake drum (6).
    Fig 2: Tire And Wheel Mounting Method
    GC0041085Courtesy of DAIMLERCHRYSLER CORP.
  6. Install tire and wheel assembly (1) (Refer to TIRES/WHEELS - INSTALLATION) . Install and tighten wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals