LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Starting System) >> Starter Motor >> Removal >> 2.2L Diesel

2.2L Diesel

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Cooling Module
GC0041000Courtesy of DAIMLERCHRYSLER CORP.
1 - UPPER RADIATOR CROSSMEMBER
2 - COOLING MODULE
3 - RADIATOR FAN CONNECTOR
4 - LOWER RADIATOR CROSSMEMBER
  1. Disconnect the negative battery cable. See Fig 1.
  2. Remove the radiator, (Refer to COOLING/ENGINE/RADIATOR - REMOVAL) .
    Fig 2: Radiator Mounting Tabs
    GC0021926Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove inner cooler from radiator by lifting the inner cooler up off of the 2 lower mounting tabs. See Fig 2 and push it toward the front of vehicle. These tabs are on the bottom of the inner cooler and lock into the bottom of the radiator.
    Fig 3: View Of Starter Location
    GC0021924Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the radiator from vehicle. See Fig 3.
    Fig 4: View Of Starter Solenoid Electrical Connections
    GC0021925Courtesy of DAIMLERCHRYSLER CORP.
  5. Disconnect the electrical connectors from the starter. See Fig 4.
  6. Disconnect the battery cable from the starter.
  7. Remove the lower mounting bolt and ground cable.
  8. Remove the upper mounting bolt.
  9. Remove starter.
scientia non olet · About LEMON Manuals