Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

1) DTC STATUS IS ACTIVE
Turn the ignition on.

With the scan tool, select View DTCs in the Wireless Control Module (SKREEM).

Is the DTC status Active at this time?

Yes
1. Go to step 2.
No
1. Go to step 4).
2) TIRE PRESSURE SENSOR
Turn the ignition off.

Replace the Tire Pressure Sensor in accordance with the Service Information.

With the scan tool, clear DTCs in the Wireless Control Module (SKREEM).

Test Drive the vehicle for a minimum of 10 minutes with vehicle speed greater than 15 m.p.h.

With the scan tool, select View DTCs in the Wireless Control Module (SKREEM).

Does the DTC reset or is the status Active for this DTC?

Yes
1. Go to step 3.
No
1. Test Complete.
3) WIRELESS CONTROL MODULE (SKREEM)
View repair.

Repair
1. Replace the Wireless Control Module (SKREEM) in accordance with the Service Information.
  Perform TPM VERIFICATION TEST (Refer to TIRES/WHEELS/TIRE PRESSURE MONITORING - DIAGNOSIS AND TESTING)
4) INTERMITTENT TIRE PRESSURE SENSOR DTC
The conditions necessary to set this DTC are not present at this time.

Refer to any Technical Service Bulletins that may apply to this condition.

With the scan tool, clear DTCs in the Wireless Control Module (SKREEM).

Test Drive the vehicle for a minimum of 10 minutes with vehicle speed greater than 15 m.p.h.

With the scan tool, select View DTCs in the Wireless Control Module (SKREEM).

Does the DTC reset or is the status Active for this DTC?

Yes
1. Return to the beginning of this test and perform the diagnostic procedure as necessary.
No
1. Test complete.