T350 Manual Transaxle: Specifications
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Back-up Lamp Switch | 24 | 18 | - |
| Crossover Cable Adj. Screw | 8 | - | 70 |
| Drain Plug | 14 | - | 120 |
| Bolts, Differential Ring Gear | 81 | 60 | - |
| Dust Shield to Transaxle | 12 | - | 105 |
| Bolts, End Plate Cover | 29 | 21 | - |
| Front Engine Mount to Trans | 108 | 80 | - |
| Front Mount Through Bolt | 61 | 45 | - |
| Bolt, Front Mount to Engine | 54 | 40 | - |
| Lateral Bending Strut to Engine | 54 | 40 | - |
| Lateral Bending Strut to Trans. | 54 | 40 | - |
| Bolt, Left Mount Through | 108 | 80 | - |
| Left Mount to Transaxle | 54 | 40 | - |
| Output Bearing Race Ret. Strap | 11 | - | 96 |
| Reverse Fork Bracket | 11 | - | 96 |
| Bolt, Reverse Idler Shaft | 29 | 19 | - |
| Shift Cable Bracket to Transaxle | 28 | - | 250 |
| Transaxle Case Bolts | 29 | 21 | - |
| Bolt, Transaxle to Engine | 95 | 70 | - |
| Vehicle Speed Sensor | 7 | - | 60 |
| Vertical Bending Strut to Engine | 108 | 80 | - |
| Vertical Bending Strut to Trans. | 108 | 80 | - |
| Bolts, Transaxle Upper Mount Bracket | 65 | 48 | - |
| Bolts, Modular Clutch-to-Driveplate | 88 | 65 | - |
| Bolts, Rear Mount Bracket-to-Transaxle | 110 | 80 | - |
| Horizontal Bolt, Rear Mount Bracket-to-Transaxle | 110 | 80 | - |
| Through Bolt, Rear Mount | 61 | 45 | - |
| Bolts, Bellhousing Case | 26 | 19 | - |
| Drain Plug, Transmission | 28 | - | 250 |
| Bolt, Reverse Idler Shaft | 26 | 19 | - |
NV T350 (A-578) MANUAL TRANSAXLE FLUID FILL
| TRANSAXLE | METRIC MEASURE | U.S. MEASURE |
|---|---|---|
| NV T350 | 2.4-2.7 Liters | 2.5-2.8 Quarts |
Bolts that have thread sealer or torque lock patches should not be reused. Always install new bolts in these applications.