Back-Up Lamp Switch: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Back-Up Lamp Switch & Connector

Courtesy of DAIMLERCHRYSLER CORP.

1 - CONNECTOR

2 - BACK UP LAMP SWITCH

Install back-up lamp switch (2). See Fig 1. Teflon tape or equivalent must be used on switch threads. Tighten switch to 24 N.m (18 ft. lbs.) torque.

CAUTION: Do not overtighten switch.

Connect back-up lamp switch connector (1).
Lower vehicle.
Verify back-up lamp operation.