Gear Shift Boot: Installation
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - GEARSHIFT BOOT |
- Position gearshift boot (1) over the operating lever and engage tab on mount ring at front to opening in console. Apply hand pressure to engage bosses on mount ring of boot to console opening slots. See Fig 1.
1 - GEARSHIFT KNOB - Position gearshift knob (1) hole over the gearshift mechanism and align the shift pattern. See Fig 2.
- Verify that shift pattern is aligned properly.
- Strike knob (1) with rubber mallet to engage knob to mechanism.