LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Fuel System) >> Fuel Injection - 2.2L Diesel >> Fuel Pressure Sensor >> Removal

Fuel Pressure Sensor: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: High-pressure fuel lines deliver fuel under extreme pressure from the injection pump to the injectors. This maybe as high as 1600 bar (23,200 psi). Use extreme caution when inspecting for high-pressure fuel leaks. Fuel under this amount of pressure can penetrate skin causing personal injury or death. Inspect high-pressure fuel leaks with a sheet of cardboard. Wear safety goggles and adequate protective clothing when servicing fuel system.
  1. Disconnect negative battery cable.
  2. Remove the engine cover. On 1.6L, (Refer to ENGINE - REMOVAL) or on 2.4L, (Refer to ENGINE - REMOVAL) .
  3. Disconnect fuel pressure sensor electrical connector. See Figure.
  4. Remove fuel pressure sensor from fuel rail. See Figure.
scientia non olet · About LEMON Manuals