Idle Air Control Motor: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Idle Air Control Valve Location

Courtesy of DAIMLERCHRYSLER CORP.

When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings or seals, damage may result. If assembly of component is difficult, use water to aid assembly.

Disconnect negative cable from battery.
Remove electrical connector from idle air control motor.
Remove idle air control motor mounting screws.

Fig 2: O-Rings
Courtesy of DAIMLERCHRYSLER CORP.

1 - O-rings
Remove motor from throttle body. Ensure the O-rings is removed with the motor.