Idle Air Control Motor: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: O-Rings

Courtesy of DAIMLERCHRYSLER CORP.

1 - O-rings

When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings or seals, damage may result. If assembly of component is difficult, a light coat of engine oil may be applied to the O-RINGS ONLY to aid assembly.

The new idle air control motor has a new O-ring installed on it.

Fig 2: Idle Air Control Valve Location
Courtesy of DAIMLERCHRYSLER CORP.
Carefully place idle air control motor into throttle body.
Install mounting screw. Tighten screw to 7 N.m (62 in. lbs.) torque.
Connect electrical connector to idle air control motor.
Connect negative cable to battery.