LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Fuel System) >> Fuel Injection (Except Diesel) >> Fuel Injector >> Standard Procedure >> Removal - Injector Connector

Removal - Injector Connector

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuel Injectors
GC0019464Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect electrical connectors at the fuel injectors.
    Fig 2: Remove/Install Injector Connector
    GC0006529Courtesy of DAIMLERCHRYSLER CORP.
  2. To remove connector pull the red colored slider away from injector (1). While pulling the slider, depress tab (2) and remove connector (3) from injector. The factory fuel injection wiring harness is numerically tagged (INJ 1, INJ 2, etc.) for injector position identification. If harness is not tagged, make note of wiring location before removal.
scientia non olet · About LEMON Manuals