Oil Supply Line
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- If brass fitting was removed from engine block or turbocharger, apply thread sealer to threads and install. Torque brass fitting to 41 N.m (30 ft. lbs.).
- Position oil supply line to mounting location.
- Hand start flared fitting at turbocharger.
- Raise vehicle on hoist.
- Hand start flared fitting at engine block.
- Torque flared fittings to 31 N.m (23 ft. lbs.).
- Install elbow support bracket.
- Lower vehicle.