Coolant Supply Line
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BANJO BOLT |
| 2 - WASHERS |
- If brass fitting was removed from engine block, apply thread sealer to threads and install in engine block. Torque brass fitting to 41 N.m (30 ft. lbs.).
- Position coolant supply line to mounting location.
- Install NEW washers (2) on banjo fitting of coolant supply line. Hand start banjo bolt. See Fig 1.
- Hand start flared fitting of coolant supply line.
- Torque banjo fitting bolt to 37 N.m (27 ft. lbs.).
- Torque flared fitting to 31 N.m (23 ft. lbs.).
- Lower vehicle.
- Fill cooling system, (Refer to COOLING/ENGINE/COOLANT - STANDARD PROCEDURE) .