Isolators-Support Brackets And: Installation
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Position isolator bracket to underbody and install attaching screws. Tighten bracket screws to frame rail to 8.5 N.m (75 in. lbs.) and bracket screws to the rear panel to 3.7 N.m (33 in. lbs.).
- Connect isolator to exhaust system component.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
- Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.