Section 81 (Rack & Pinion Power Steering System): Pump: Reservoir: Removal: 2.4L

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, (Refer to STEERING - WARNING) .

Fig 1: Hose Connection At Reservoir

Courtesy of DAIMLERCHRYSLER CORP.

1 - POWER STEERING FLUID RESERVOIR

2 - ENGINE COVER

3 - SUPPLY HOSE

4 - RETURN HOSE

Remove the filler cap from the remote power steering fluid reservoir (1).
Siphon as much fluid as possible from the fluid reservoir.
Remove the plastic engine cover.
Remove the clamp attaching the supply hose (3) to the power steering fluid reservoir. Remove the hose from the reservoir.
Remove the clamp attaching the return hose (4) to the power steering fluid reservoir. Remove the hose from the reservoir.

Fig 2: Power Streering Fluid Reservoir Mounting
Courtesy of DAIMLERCHRYSLER CORP.

1 - MOUNTING BOLTS

2 - POWER STEERING FLUID RESERVOIR
Remove the two bolts (1) fastening the reservoir (2) to the rear of the engine. Remove the reservoir.