Section 81 (Rack & Pinion Power Steering System): Pump: Hose-Supply: Removal: 2.4L

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, (Refer to STEERING - WARNING) .

Siphon as much fluid as possible from the power steering fluid reservoir.

Fig 1: Grille Attachment
Courtesy of DAIMLERCHRYSLER CORP.

1 - GRILLE

2 - RETAINER
Remove the grille (1) from the front of the vehicle. (Refer to BODY/EXTERIOR/GRILLE - REMOVAL) .
Remove the hood-opening weather-strip from across the radiator closure panel.

Fig 2: Ambient Temperature Sensor
Courtesy of DAIMLERCHRYSLER CORP.

1 - FASTENER

2 - SENSOR
Remove the fastener (1), then the ambient temperature sensor (2) from the radiator closure panel.

Fig 3: Radiator Closure Panel
Courtesy of DAIMLERCHRYSLER CORP.

1 - FASTENERS
Remove the fasteners (1) securing the upper radiator closure panel in place, then remove the panel.

Fig 4: Supply Hose At Pump
Courtesy of DAIMLERCHRYSLER CORP.

1 - SUPPLY HOSE CLAMP

2 - POWER STEERING PUMP

Remove the clamp (1) securing the supply hose to the power steering pump (2) supply fitting, then remove the hose from the supply fitting.

Fig 5: Hose Connection At Reservoir

Courtesy of DAIMLERCHRYSLER CORP.

1 - POWER STEERING FLUID RESERVOIR

2 - ENGINE COVER

3 - SUPPLY HOSE

4 - RETURN HOSE

Remove the hose clamp securing the supply hose (3) to the power steering fluid reservoir (1). Slide the hose off the end of the reservoir fitting and remove from vehicle.