Ignition Switch

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IGNITION SWITCH MOUNTING SCREW

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: Lock cylinder housing previously removed.

Lower the column tilt lever to the full-downward position.
Remove the ignition switch (2) mounting screw (1).

Fig 2: IGNITION SWITCH REMOVAL/INSTALLATION
Courtesy of DAIMLERCHRYSLER CORP.
Pull the switch (1) straight out and off the retaining tabs (2) located on the lock cylinder housing.