Ignition Switch

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IGNITION SWITCH REMOVAL/INSTALLATION

Courtesy of DAIMLERCHRYSLER CORP.

Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
Align the ignition switch with the pin (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the switch snapping it into place over the retaining tabs.

Fig 2: IGNITION SWITCH MOUNTING SCREW
Courtesy of DAIMLERCHRYSLER CORP.
Install the ignition switch (2) mounting screw (1). Tighten the screw to 2 N.m (18 in. lbs.).