Right Link

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)

Fig 1: Tire And Wheel Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Remove wheel mounting nuts (3), then rear tire and wheel assembly (1).

Fig 2: WSS Routing Along Left Toe Link
Courtesy of DAIMLERCHRYSLER CORP.
If equipped, remove wheel speed sensor cable (2) from toe link.

Fig 3: Rear Toe Adjustment Bolt Nut
Courtesy of DAIMLERCHRYSLER CORP.
While holding toe adjustment cam bolt from rotating, remove nut (3) securing toe link at crossmember (1).

Fig 4: Toe Link Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Slide cam bolt (2) rearward out of crossmember and link (1).
Remove mounting bolt (3) and nut at knuckle.
Remove toe link (1).