Hub And Bearing: Description
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
The rear wheel bearing and wheel hub of this vehicle are a one piece sealed unit or hub and bearing unit type assembly. The hub and bearing (1) is mounted to the center of the knuckle using 4 bolts. It has five wheel mounting studs (2) on the hub flange.
The center of the hub and bearing is splined to match the axle half shaft.
The wheel mounting studs used to mount the tire and wheel to the vehicle are the only replaceable components of the hub and bearing. Otherwise, the hub and bearing is serviced only as a complete assembly.