Hub And Bearing: Removal: RWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)

Fig 1: Tire And Wheel Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Remove wheel mounting nuts (3), then tire and wheel assembly (1).
Access and remove front brake rotor. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTOR - REMOVAL)

Fig 2: Dust Cap and Hub Nut
Courtesy of DAIMLERCHRYSLER CORP.
Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
Remove hub nut (1).
Slide hub and bearing off knuckle spindle.