Hub And Bearing: Removal: AWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)

Fig 1: Tire And Wheel Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Remove wheel mounting nuts (3), then tire and wheel assembly (1).

Fig 2: Locating Axle Shaft Hub Nut
Courtesy of DAIMLERCHRYSLER CORP.
While a helper applies brakes to keep hub from rotating, remove hub nut (1) from the axle half shaft (2).
Access and remove front brake rotor. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTOR - REMOVAL)

Fig 3: Locating Halfshaft at Hub/Bearing Assembly
Courtesy of DAIMLERCHRYSLER CORP.
Remove four bolts (3) fastening hub and bearing (2) to knuckle.
Slide hub and bearing (2) off axle half shaft (1) and knuckle.