Rear Door Latch: Removal
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - REAR DOOR POWER LOCK ACTUATOR TO LATCH LINK |
| 2 - REAR DOOR OUTSIDE HANDLE TO LATCH LINK |
| 3 - REAR DOOR LOCK LATCH |
| 4 - REAR DOOR INSIDE ROD TO LATCH LINK AND SLEEVE |
| 5 - REAR DOOR BELLCRANK TO LATCH LINK AND SLEEVE |
- Remove door trim panel.
- Raise door glass to full up position.
- Remove lower rear run channel.
- Disconnect clips attaching linkage rods to door latch.
- Remove linkage rods from latch.
- Remove screws attaching latch to door end frame
- Remove door latch from vehicle.