Stripes And Decals-Body: Removal
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Mark decal attachment locations on the body as necessary with a grease pencil or other suitable device to provide reference marks for installation.
- Using a heat gun, gently apply heat in a circular motion to loosen the adhesive bond that secure the molding decals (4, 5, 6, 7 and 9) and woodgrain decals (1, 2, 3 and 8) to the body, as required.
- Using a trim stick C-4755 or equivalent, remove the decals by gently pry up at the corners and carefully pulling on the remaining portion of the decal.
- Clean off all traces of adhesive from the panels with a general purpose adhesive remover.