Removal - Convertible

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: A-Pillar Molding

Courtesy of DAIMLERCHRYSLER CORP.

CAUTION: Replacement of the header molding retaining clips is required anytime a header molding is reinstalled. Failure to replace the snap-type retaining clips can result in poor header molding retention.

Remove the header molding (Refer to BODY/EXTERIOR/MOLDING-HEADER - REMOVAL) .
Remove the screw (1) that secures each A-pillar molding (2) to the windshield opening frame.
Using a trim stick C-4755 or equivalent, remove each A-pillar molding by releasing the two snap retainers from the windshield opening frame.