LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Interior & Exterior (1 Of 2)) >> Convertible Top >> Assembly-Wire Harness >> Removal

Assembly-Wire Harness: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Convertible Top Well
GC0022247Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the convertible top in the raised position.
  2. Remove the rear seat cushion (Refer to BODY/SEATS/CUSHION-REAR - REMOVAL) .
  3. Remove the left interior quarter trim panel (Refer to BODY/INTERIOR/TRIM-REAR QUARTER PANEL - REMOVAL) .
  4. Remove the rear seat back (Refer to BODY/SEATS/SEAT BACK-REAR - REMOVAL) .
  5. Remove the push-pins (1) that secure the convertible top well (2) to the rear seat back panel (3) and body (4) and remove the well liner.
    Fig 2: Hydraulic Pump Protective Cover
    GC0022255Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the protective cover (3) from the top of the hydraulic pump/motor assembly (4) located on the shelf panel (2).
    Fig 3: Motor/Hydraulic Pump Assembly
    GC0022254Courtesy of DAIMLERCHRYSLER CORP.
  7. Disconnect the wire connector for the pump motor (1).
  8. Remove the three retaining clips that secure the convertible top wire harness (3) and relay (2) to the body.
    Fig 4: Convertible Top Wire Harness
    GC0042990Courtesy of DAIMLERCHRYSLER CORP.
  9. Disconnect the two wire harness connectors from the rear window defogger terminals and route the defogger wire harness lead (1) through the wire slings.
  10. Disconnect the convertible top wire harness connector (2) from the body wire harness (3) located on the left side of the vehicle and remove the convertible top wire harness.
scientia non olet · About LEMON Manuals