LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (HVAC Systems (Service Information)) >> Plumbing >> Diagnosis And Testing >> Refrigerant System Leaks >> System Empty

System Empty

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Evacuate the refrigerant system to the lowest degree of vacuum possible (approximately -88 kPa (- 26 in. Hg) or greater vacuum), (Refer to REFRIGERANT SYSTEM EVACUATE) . Determine if the system holds a vacuum for 15 minutes. If vacuum is held, a leak is probably not present. If system will not maintain vacuum level, proceed to step  2.
  2. Prepare and dispense 0.284 kilograms (10 ounces) of R-134a refrigerant into the evacuated refrigerant system, (Refer to REFRIGERANT SYSTEM CHARGE)  and proceed to step  1 under SYSTEM LOW procedure.
scientia non olet · About LEMON Manuals