LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (HVAC Systems (Service Information)) >> Controls >> Switch-A/C Low Pressure >> Installation

Switch-A/C Low Pressure: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: A/C Low Pressure Switch - Typical
GC0020905Courtesy of DAIMLERCHRYSLER CORP.
  1. Lubricate a new O-ring seal with clean refrigerant oil and install it onto the accumulator fitting. Use only the specified O-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  2. Install the A/C low pressure switch (2) onto the top of the A/C accumulator (1). Hand-tightened the switch securely.
  3. Connect the wiring harness connector (3) to the A/C low pressure switch.
  4. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals