LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (HVAC Systems (Service Information)) >> Controls >> Switch-A/C High Pressure >> Removal

Switch-A/C High Pressure: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Review safety precautions and warnings in this group before performing this procedure (Refer to HEATING & AIR CONDITIONING/PLUMBING - WARNINGS)  and (Refer to HEATING & AIR CONDITIONING/PLUMBING - CAUTIONS) . Failure to follow the warnings and cautions could result in possible personal injury or death.
Fig 1: Removing/Installing A/C High Pressure Switch
GC0043300Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system (Refer to REFRIGERANT SYSTEM RECOVERY) .
  3. Raise and support the vehicle.
  4. Disconnect the wire harness connector (1) from the A/C high pressure switch (2) located at the rear of the A/C compressor (3).
  5. Using snap ring pliers (Special Tool C-4574 or equivalent), remove the internal snap ring that secures the A/C high pressure switch to the A/C compressor.
  6. Remove the A/C high pressure switch from the A/C compressor and remove and discard the O-ring seal.
scientia non olet · About LEMON Manuals