LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (HVAC Systems (Service Information)) >> Controls >> Actuator-RECIRCULATION Door >> Removal

Actuator-RECIRCULATION Door: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
Fig 1: Duct - Right Floor Distribution
GC0043288Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side instrument panel silencer, (Refer to BODY/INSTRUMENT PANEL/SILENCER-INSTRUMENT PANEL - REMOVAL) .
  3. Remove the glove box bin, (Refer to BODY/INSTRUMENT PANEL/BIN-GLOVE BOX - REMOVAL) .
  4. Remove the floor center console. (Refer to BODY/INTERIOR/CONSOLE-CENTER - REMOVAL) .
  5. Remove the screw (1) that secures the right floor distribution duct (2) to the right side of the HVAC air distribution housing (4).
  6. Disconnect the right floor distribution duct from the air distribution housing outlet and the right rear floor duct (3).
    Fig 2: Removing/Installing Actuator-Recirculation Door
    GC0043289Courtesy of DAIMLERCHRYSLER CORP.
  7. Position the right floor distribution duct (1) out of the way and remove the screws (5) that secure the recirculation door actuator (2) to the left side of the HVAC air inlet housing (3).
  8. Remove the recirculation door actuator from the air inlet housing and disconnect the wire harness connector (4) from the actuator.
  9. Remove the recirculation door actuator from the vehicle.
scientia non olet · About LEMON Manuals