Sensor/Switch-Oil Pressure: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Oil Pressure Switch

Courtesy of DAIMLERCHRYSLER CORP.

1 - EXHAUST MANIFOLD HEAT SHEILD

2 - OIL FILTER

3 - OIL PRESSURE SWITCH

Install oil pressure switch (3) and connect electrical connector. See Figure.
Lower vehicle.
Start engine and allow to run a minimum of 2 minutes.
Shut engine off and check engine oil level. Adjust level as necessary.