LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (1.6L SOHC Engine) >> Manifold-Intake >> Removal >> Upper Intake Manifold

Upper Intake Manifold

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Upper Intake Manifold
GC0021555Courtesy of DAIMLERCHRYSLER CORP.
1 - PURGE SOLENOID VACUUM HOSE
2 - UPPER INTAKE FASTENERS
3 - PCV HOSE
4 - MANIFOLD SUPPORT BRACKET FASTENERS
  1. Disconnect negative battery cable.
  2. Disconnect throttle body air inlet hose and purge solenoid vacuum hose (1) from throttle body. See Fig 1.
  3. Disconnect PCV hose (3) from upper intake manifold. See Fig 1.
  4. Disconnect brake booster vacuum hose.
  5. Disconnect electronic throttle control motor electrical connector.
  6. Remove upper intake manifold support bracket fasteners (4). See Fig 1.
  7. Remove upper intake manifold fasteners (2). See Fig 1.
  8. Remove upper intake manifold and gasket.
scientia non olet · About LEMON Manuals