Section 75 (1.6L SOHC Engine): Damper-Vibration: Installation
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - SPECIAL TOOL 8385 |
| 2 - VIBRATION DAMPER |
- Install crankshaft vibration damper (2) using Special Tool 8385 installer (1). See Fig 1.
- Install vibration damper bolt. Tighten bolt to 115 N.m (85 ft. lbs.).
- Install the accesory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELT - INSTALLATION) .
- Install the accessory drive belt splash shield and right wheel.
- Lower the vehicle.
- Connect negative battery cable.