Integrated Control Unit (ICU): Disassembly

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: ICU Mounting Bolt

Courtesy of DAIMLERCHRYSLER CORP.

1 - ICU

2 - MOUNTING BOLT

3 - MOUNTING BRACKET

If the mounting bracket (3) needs to be removed from the ICU, remove the single mounting bolt (2), then slide the ICU's mounting pins out of the grommets in the bracket. Remove the mounting pins from the ICU as necessary.

Fig 2: ABM Mounting Screws - Without Traction Control
Courtesy of DAIMLERCHRYSLER CORP.

1 - MOUNTING SCREWS

2 - ABM
If not equipped with traction control, remove the three screws (1) attaching the ABM (2) to the HCU.

Fig 3: ABM Mounting Screws - With Traction Control
Courtesy of DAIMLERCHRYSLER CORP.

1 - MOUNTING SCREWS

2 - ABM
If equipped with traction control, remove the four screws (1) attaching the ABM (2) to the HCU.

Fig 4: ABM Assembly to HCU
Courtesy of DAIMLERCHRYSLER CORP.

1 - ABM

2 - HCU

3 - SOLENOID VALVE STEM
Separate the ABM (1) from the HCU (2).