Section 71 (Mechanical Brake System - Base (Service Information)): Drum: Removal: Notes

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, (Refer to BRAKES - WARNING) (Refer to BRAKES - CAUTION) .

Raise vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)

Fig 1: Tire And Wheel Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Remove the wheel mounting nuts (3), then the tire and wheel assembly.

Fig 2: Drum Brake Mounting To Axle
Courtesy of DAIMLERCHRYSLER CORP.
Remove the brake drum retaining clips (5) (if equipped).
Slide the brake drum off the wheel mounting studs of the hub (7) and remove it from the vehicle. If the drum does not come off, further brake clearance can be obtained by backing off the brake adjuster screw. To do so perform the following procedure.