Section 71 (Mechanical Brake System - Base (Service Information)): Drum: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before installing drum, inspect brake shoe linings for wear, alignment, and contamination. Repair or replace as necessary.

NOTE: If rust or any foreign material is present on hub, drum or wheel mating surfaces, wet wire brush these areas to remove prior to assembly of parts.

Properly remove any buildup formed along outer edge of drum's machined braking surface.
Adjust the brake shoes-to-drum diameter using a brake shoe gauge. (Refer to BRAKES/HYDRAULIC/MECHANICAL/BRAKE PADS/SHOES - ADJUSTMENTS)

Fig 1: Drum Brake Mounting To Axle
Courtesy of DAIMLERCHRYSLER CORP.
Slide the brake drum (6) onto the wheel mounting studs on the hub and bearing (7).

Fig 2: Tire And Wheel Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Install the tire and wheel assembly (1) (Refer to TIRES/WHEELS - INSTALLATION) . Install and tighten the wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
Lower the vehicle.
Road test the vehicle stopping in both forward and reverse directions. The automatic-adjuster will continue to adjust the brakes as necessary during the road test.