Seal-Axle Shaft: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Axle Seal Installation

Courtesy of DAIMLERCHRYSLER CORP.

Using Tool 9223 (2), install NEW axle shaft seal (1). Lubricate the inside diameter with Mopar® Gear and Axle Lubricant 75W-140 to protect seal during halfshaft installation.
Install halfshaft(s). (Refer to DIFFERENTIAL & DRIVELINE/HALF SHAFT - INSTALLATION)

Fig 2: Rear Axle Fill Plug
Courtesy of DAIMLERCHRYSLER CORP.
Remove fill plug (1) to check and adjust rear axle fluid level. Top off axle with Mopar® Gear and Axle Lubricant 75W-140. Reinstall fill plug torque to 60 N.m (44 ft. lbs.) torque.