LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> Sensor-Engine Coolant Temp >> Removal >> 2.0L/2.4L Engine >> Turbo

2.0L/2.4L Engine: Turbo

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Coolant Temperature Sensor - 2.4L Turbo
GC0021847Courtesy of DAIMLERCHRYSLER CORP.
1 - COOLANT OUTLET CONNECTOR
2 - ENGINE COOLANT TEMPERATURE SENSOR
  1. Disconnect negative battery cable.
  2. Partially drain cooling system below level of engine coolant temperature sensor (2).
  3. Remove upper torque strut, (Refer to ENGINE/ENGINE MOUNTING/TORQUE STRUT - REMOVAL) .
  4. Disconnect engine coolant temperature sensor electrical connector.
  5. Remove engine coolant temperature sensor (2). See Figure.
scientia non olet · About LEMON Manuals