2.2L Diesel
WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - COOLANT RECOVERY PRESSURE CONTAINER |
| 2 - DASH PANEL |
| 3 - COOLANT HOSE |
| 4 - RETAINING BOLTS |
| 5 - RETAINING NUT |
- Disconnect negative battery cable.
- Remove engine cover.
- Partially drain cooling system using the draincock only, (Refer to COOLING/ENGINE/COOLANT - STANDARD PROCEDURE) . Drain system below level of the coolant recovery pressure container.
- Remove fuel filter assembly mounting bracket retaining screws and reposition assembly towards left side of the engine compartment.
- Disconnect coolant bypass hose (3) at coolant recovery pressure container (1).
- Remove coolant recovery pressure container fasteners (4, 5). See Fig 1.
- Lift container up at disconnect coolant hose (3) from bottom.
- Remove coolant recovery pressure container from engine compartment.